Smarol NANO

Фасовка Ціна Кількість
150г 155.40 UAH
Сума (UAH):
0.00

Quality class:  NLGI 2

 

General features

SMAROL NANO for mowers and trimmers is designed for lubrication of intersecting axis gears in combustion cutters and trimmers. Grease is produced from high quality base oil thickened with complex lithium soaps. Grease is the enriched with anticorrosive additives and EP. Due to the thickener used, these additives are characterized by high dropping point and high mechanical stability. This grease is resistant to corrosion, oxidation and water washout. It contains a unique NANO formula, due to which the grease adheres perfectly to lubricated surfaces, forming a tough layer resistant to high loads, moisture, acids, alkalis, and very high temperatures. The use of the substance with the lowest currently known friction coefficient of less than 0.03 WT provides very good anti-seizing properties.

 

Colour: silver-black

 

Application

SMAROL NANO for mowers and trimmers is designed primarily for lubricating intersecting axis gears in any kind of mowers and trimmers, combustion and electric ones. It can be successfully used in hope applications, at workshops and farms for lubrication and anti-corrosion protection of hinges, locks, threading, and parts of vehicles and machines.

SMAROL NANO for mowers and trimmers is designed for use in a wide temperature range, from -30 ° C to +160 ° C, and in dry lubrication conditions, even up to over 500°C.

SMAROL NANO for mowers and trimmers ensures reduced wear and friction resistance, which is achieved by very high welding load parameters- 500 Kg and very low scar diameter - 0.5 mm.

 

Physical and chemical properties

 

No.

Properties

Requirements

1.

Worked penetration in temp. 25°C, [0,1 mm]

281

2.

Dropping point [0C]

232

3.

Resistance to water washout with dynamic method 790C, [%]

1

4.

Weld load, [Kg]

500

5.

Scar diameter (40 kG, 1h), [mm]

0,5

 

ATTENTION: Physicochemical parameters listed in the table are typical values. Real values are stated in quality control certificates attached to each product lot.