ACP-1E

Фасовка Ціна Кількість
205л 15092.70 UAH
Сума (UAH):
0.00

Quality class: 

Viscosity grad:           

 

General features

 

ACP-1E, 2E, 3E non-emulsifying machining oils were developed meeting strict ecological requirements. These oils are free from chlorine compounds..

Application

 

ACP-1E, 2E, 3E non-emulsifying oils are mainly intended for machining of steel, cast-iron, copper and aluminium alloys in case of high unit pressure and high cutting speed.

 

Oil selection depends on machining kind:

• ACP-1E is used for turning of steel, cast iron as well as copper and aluminium alloys, for slotting of tooth, reaming and screw cutting.

• ACP-2E is used for hobbing, reaming of steel, screw cutting, rolling, whitening, pull broaching and push broaching,

• ACP-3E is used for deep drilling and for working with automatic machining centres.

Standards, approvals, specifications

 

Polish National Institute of Hygiene (PZH) approval

Physical and chemical properties

 

Parameters

Unit

Typical values

Kinematic viscosity at 20C

mm2/s

38,6

Kinematic viscosity at 40C

mm2/s

16,7

Solidification point

C

-3

Ignition temperature

C

148

Corrosiveness to copper and steel 1000C/3h

reference sample

tough

ATTENTION: Physicochemical parameters listed in the table are typical values. Real values are stated in quality control certificates attached to each product lot.