ACP-2E

Фасовка Ціна Кількість
517.44 UAH
20л 1967.10 UAH
205л 15337.26 UAH
Сума (UAH):
0.00

General features

ACP-1E, 2E, 3E non-emulsifying machining oils were developed meeting strict ecological requirements. These oils are free from chlorine compounds.

Application

ACP-1E, 2E, 3E non-emulsifying oils are mainly intended for machining of steel, cast-iron, copper and aluminium alloys in case of high unit pressure and high cutting speed. 

Oil selection depends on machining kind:

• ACP-1E is used for turning of steel, cast iron as well as copper and aluminium alloys, for slotting of tooth, reaming and screw cutting.
• ACP-2E is used for hobbing, reaming of steel, screw cutting, rolling, whitening, pull broaching and push broaching,
• ACP-3E is used for deep drilling and for working with automatic machining centres.

Standards, approvals, specifications

Polish National Institute of Hygiene (PZH) approval

Physical and chemical properties

Parameters  Unit  Typical values
Kinematic viscosity at 200Cmm2/s53,1
Kinematic viscosity at 400Cmm2/s21,3
Solidification point0C-15
Ignition temperature  0C153
Corrosiveness to copper and steel 1000C/3hreference sampletough
ATTENTION: Physicochemical parameters listed in the table are typical values. Real values are stated in quality control certificates attached to each product lot.